
MTS Technik - Coilover Kit Street Volkswagen Golf III
By MTS Technik
NZD$1,712.75
- SKU:
- MTSGWVW44
- Width:
- 100.00 (cm)
- Height:
- 40.00 (cm)
- Depth:
- 40.00 (cm)
Save Extra 35% Off on First Order
Coilover Kit Street Volkswagen Golf III
Coilover Kit Street MTS Technik for Volkswagen Golf III, lowering both axles between 25 - 80 mm. Dedicated for the years of: 01/93 - 07/97, for the engine version: 1.8 Syncro / 2.0 Syncro / 2.9 VR6 Syncro / 1.9TDI Syncro.

High quality confirmed by a 2-year warranty without a mileage limit.

Suspension components characterized by increased corrosion resistance and made of the highest quality materials.

The use of twin-tube technology guarantees stable shock absorber performance.

Pressurized gas presses the hydraulic fluid, eliminating the "foaming" effect of the oil (an undesirable and typical for oil shock absorbers phenomenon), which means higher efficiency for continuous, intensive work.

Specially selected type of thread and a wide range of suspension adjustment allows optimal setting of the car height.

Innovative hexaCOIL spring perch, significantly increasing the comfort of suspension height adjustment.

Adjustable Shock Absorbers protected by a double layer of gold zinc and adjustments made of anodized aluminum guaranteeing increased corrosion resistance.

Coilover springs made by Eibach, the world leader in the sport springs industry.
CAR:
Make |
Volkswagen
|
Model |
Golf III
|
Type |
1H1
|
Engine |
1.8 Syncro / 2.0 Syncro / 2.9 VR6 Syncro / 1.9TDI Syncro
|
Year |
01/93 - 07/97
|
TECH SPECS:
Series: | street |
![]() |
1035 kg
|
![]() |
1060 kg
|
Lowering FA: |
25 - 80 mm
|
Lowering RA: |
25 - 80 mm
|
TUV Certificate: |
yes
|
Download instruction: | Download instruction |
Download installation manual: | Download installation manual |
Download TUV Certificate: | Download TUV Certificate |
PRODUCT NOTES
2 - Front and rear axle height adjustable (threaded shock absorber housing).
21 - If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
24 - During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.